Premaintenance Procedures; Opening The Access Covers - Toro 22336 Operator's Manual

Premaintenance
Procedures

Opening the Access Covers

Removing the Front Access Cover
1. Raise the loader arms and install the cylinder locks.
Note: In the case that you need to remove the front
access cover without raising the loader arms, be very
careful not to damage the cover or hydraulic hoses
as you maneuver the cover out from under the arms.
2. Stop the engine and remove the key.
3. Release the two locking tabs (Figure 25, top, left tab
illustrated).
Figure 25
4. Pull the cover off of the traction unit.
5. When finished, replace the front access cover and
secure it with the two locking tabs.
Opening the Rear Access Cover
1. Stop the engine and remove the key.
2. Release the two locking tabs on top of the rear access
cover (Figure 26).
1. Rear access cover
2. Locking tabs
3. Remove the bolt located next to the right locking
tab (Figure 26).
4. Grasping the handle, pull the cover up and back to
swing it open (Figure 26).
5. When finished, close the rear access cover by
swinging it up and seating it in place.
6. Secure it with the two locking tabs and bolt.
28
Figure 26
3. Bolt