Duracell DG66M-R62 Owner's Manual page 19

2. First, you'll place the wheels on the frame.
To do this, place the washer on the axle and insert it from the inside of the
frame toward the outside of the frame as shown at right;
Then, install the spacer as shown;
Place wheel onto axle;
Secure wheel with nut and then repeat the steps above on the other
wheel: *Use M16 x 1.5 nuts
3. Next, attach the front support. On the handle side of the
generator, lift and support the bottom of the frame to enable the
assembly of the front support: *Use M8 x 16 bolts and M8 nuts.
Then, fasten the foot bar onto the generator by
threading the bolts into the holes in the frame of the
generator at the points shown. Tighten the bolts.
4. The last step is attaching the handle.
DG66M-R62, -B62 & DG67M-R62, -B62
17 | P a g e