Think Safety First - Toro 74266CP Operator's Manual

There is no rollover protection when the roll
bar is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll
bar is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e. branches, doorways, electrical wires)
before driving under any objects and do
not contact them.
Important: Lower the roll bar only when
absolutely necessary.
1. To lower the roll bar, remove the hairpin cotter
pins and remove the two pins (Figure 7).
2. Lower the roll bar to the down position. There
are two down positions. See Figure 6 for the
positions.
3. Install the two pins and secure them with the
hairpin cotter pins (Figure 7).
Figure 6
1. Full down position
Important: Ensure that the rear part of
the seat is secured with the seat latch.
2. Down position with bagger
installed
4. To raise the roll bar, remove the hairpin cotter
pins and remove the two pins (Figure 7).
5. Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins (Figure 7).
Important: Always use the seat belt with
the roll bar in the raised position.
1. Roll bar
2. Raised position

Think Safety First

Please read all safety instructions and symbols
in the safety section. Knowing this information
could help you or bystanders avoid injury.
17
Figure 7
3. Pin
4. Hairpin cotter pin