Table of Contents
Advertisement
2
3
4
Figure 37
1. Battery
2. Positive battery post
3. Bolt, washer, and nut
4. Terminal boot
Charging the Battery
Service Interval: Before storage—Charge the battery
and disconnect battery cables.
1. Remove the battery from the chassis; refer to
Removing the Battery.
2. Charge the battery for a minimum of 1 hour at 6 to
10 amps. Do not overcharge the battery.
3. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the
charger leads from the battery posts (Figure 38).
Figure 38
1. Positive battery post
2. Negative battery post
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.
6
5
1
7
G005072
5. Negative battery post
6. Wing nut, washer, and bolt
7. Battery hold-down
3. Red (+) charger lead
4. Black (-) charger lead
Installing the Battery
1. Position the battery in the tray with the terminal
posts toward the operating position (Figure 37).
2. Install the positive (red) battery cable to the positive
(+) battery terminal using the fasteners removed
previously.
3. Install the negative battery cable to the negative
(-) battery terminal using the fasteners removed
previously.
4. Slide the red terminal boot onto the positive (red)
battery post.
5. Secure the battery with the hold-down (Figure 37).
6. Install the left side console. Refer to the Accessing
the Battery procedure in Premaintenance Procedures
for instructions.
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse:
• Main F1-30 amp, blade-type
• Charge Circuit F2-25 amp, blade-type
1. Remove the four screws securing the control panel
to the machine. Retain all fasteners
2. Lift the control pane up to access the main wiring
harness and fuse block (Figure 39).
3. To replace a fuse, pull out on the fuse to remove it
(Figure 39).
2
1. Main-30 amp
4. Return the control panel to its original position. Use
the four screws removed previously to secure the
panel to the machine.
32
1
g012173
Figure 39
2. Charge circuit-25 amp
Advertisement
Table of Contents
