Engine Maintenance; Servicing The Air Cleaner - Toro 74380 Operator's Manual

Hide thumbs Also See for 74380:
Table of Contents

Advertisement

4. Connect a grease gun to each fitting (Figure 26 and
Figure 27). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily—Check the
air cleaner for dirty, loose or damaged
parts.
This engine is equipped with a replaceable, high density
paper air cleaner element. Check the air cleaner daily or
before starting the engine. Check for a buildup of dirt
and debris around the air cleaner system. Keep this area
clean. Also check for loose or damaged components.
Replace all bent or damaged air cleaner components.
Note: Operating the engine with loose or damaged air
cleaner components could allow unfiltered air into the
engine causing premature wear and failure.
Note: Service the air cleaner more often under
extremely dusty, dirty conditions.
4
4
3
3
1. Knobs, air cleaner cover
2. Air cleaner cover
Servicing Paper Element
Service Interval: Every 25 hours—Service the paper
element. (more often under extremely
dusty, dirty conditions)
Every 100 hours—Replace the paper
element. (more often under extremely
dusty, dirty conditions)
1. Remove the air cleaner cover (Figure 28).
2. Remove the air cleaner element with the integral
rubber seal (Figure 28).
3. Gently tap the pleated side of the paper element to
dislodge dirt. Do not wash the paper element or
use pressurized air, as this will damage the element.
26
2
2
G005300
Figure 28
3. Paper element
4. Air cleaner base
1
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timecutter z4200

Table of Contents