Servicing The Spark Plug - Toro 74936 Operator's Manual

1
3
5
3/4
Note: Ensure the oil filter gasket touches the engine
and then an extra 3/4 turn is completed.
4. Fill the crankcase with the proper type of new oil;
refer to Changing the Oil.
2
4
Figure 55

Servicing the Spark Plug

Service Interval: Every 200 hours—Check, clean and
G015196
Make sure the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug(s) and a gapping tool/feeler gauge to
check and adjust the air gap. Install a new spark plug(s)
if necessary.
Type : Champion
Air Gap: 0.030 inch (0.76 mm)
Removing the Spark Plug
1. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
2. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
3. Remove the lefthand hydraulic unit shroud in the
order listed with Figure 56. This gives you access
to the front spark plug.
G015198
40
regap the spark plug.
Every 600 hours—Replace the spark
plugs.
®
XC10YC or equivalent