Toro 74936 Operator's Manual page 30

Figure 41
1. Z Stand (Positioned in
slot)
2. Crack in side walk or turf
4. Set the foot of stand on the ground and rest the
latch on the pivot tab (Figure 41).
5. Start the engine and put it at half throttle.
Note: For best results, place the foot of stand into
seams in sidewalks or into the turf (Figure 41).
6. Drive onto the stand. Stop when the latch drops
over the tab into the locked position (Figure 41).
Once onto the stand, engage the parking brake and
tun off the engine.
7. Chock or block the drive wheels.
WARNING
Parking brake may not hold machine parked
on Z Stand and could cause personal injury or
property damage.
Do not park on Z Stand unless wheels are
chocked or blocked.
8. Perform the maintenance.
Driving off the Z Stand
1. Remove the chocks or blocks.
2. Raise the latch to the unlocked position (Figure 42).
3. Latch resting on pivot tab
1. Z Stand
2. Latch
3. Start the engine and place it at half throttle.
Disengage the parking brake.
4. Slowly drive backwards off of the stand.
5. Return the stand to its rest position (Figure 40).
30
Figure 42
3. Locked position
4. Unlocked position