Adjusting The Anti-Scalp Rollers - Toro 74936 Operator's Manual

Figure 26
Transport Lock Positions
1. Transport lock
2. Lock position—mower
deck will lock into transport
position
3. Unlock position—does not
lock the mower deck into
transport position
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 1 to 5-1/2 inches
(25 to 140 mm) in 1/4 inch (6 mm) increments by
relocating the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck lift pedal with your foot and raise
the mower deck to the transport position (also
the 5-1/2 inch (140 mm) cutting height position)
(Figure 27).
3. To adjust, rotate the pin 90 degrees and remove the
pin from the height-of-cut bracket (Figure 27).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired and,
insert the pin (Figure 27).
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
1. Deck lift pedal
2. Cut of height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade control switch (PTO), move
the motion control levers to the neutral locked
position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
24
Figure 27
3. Transport lock