Install Handles; Connect Throttle Cable - Toro 30332 Operator's Manual

8. If clearance is not correct, loosen control panel and
adjust it side–to–side. Tighten control panel.
1
4 4
3
Figure 5
1. Shift lever, 2nd gear
2. Control panel

Install Handles

1. Align handle with upper mounting hole in rear frame
(Fig. 6).
2. Secure each upper mounting hole with a flange bolt
(3/8 x 1 in. (26 mm)) and flange nut (Fig. 6).
3. Select low, middle or high position for the lower
mounting hole (Fig. 6). This allows the upper handle
to be adjusted to the user's height preference.
4. Secure each lower mounting hole with a flange bolt
(3/8 x 1 in. (26 mm)) and flange nut (Fig. 6).
5. Repeat procedures for opposite handle.
Note: If handle position is ever changed the control rods
and brakes will need to be readjusted.
2
Rear View
2
m–5458
3. Shift lever, neutral
4. Equal distance
15
Figure 6
1. Handle
2. Rear frame
3. Flange bolt, 3/8 x 1 in. (26
mm)
4. Flange nut, 3/8 in.
Install Control Rods
1. Thread rod fittings equal distance onto each control
rod (Fig. 7).
2. Install rod fittings with clevis pins into holes in idler
brackets (Fig. 7). Secure with washers and hairpin
cotters (Fig. 7).
Note: Install rod fittings so the clevis pin is above the
control rod, as shown in figure 7.
6
4
Figure 7
1. Control rod
2. Idler bracket
3. Hairpin cotter
m–5382
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. Middle position
9. High position
1
3
5
2
m–5385
4. Clevis pin
5. Washer
6. Rod fitting