Fisher & Paykel DishDrawer DD603 Installation Instructions Manual page 11

INSTALLATION INSTRUCTIONS
STEP 9:
MEASURING THE TOE KICK
STEP 10:
TRIMMING THE TOE KICK
(DOUBLE MODELS ONLY)
21
Bottom edge
of tub side
(DOUBLE MODELS ONLY)
22
23
24
21
Partially open the bottom drawer. Turn Prefinished Toe Kick
upside down and hold vertically against the bottom edge of the
Tub side (not the drawer front).
Mark the position of the bottom edge of the Tub side on the Toe Kick.
Choose the nearest groove to the pencil mark which will result
in the shortest Toe Kick.
Important!
Before cutting ensure the Toe Kick is positioned on a wooden
chopping board to avoid damage to surrounding area.
22
On the chosen groove cut down the vertical ribs at the centre and
the ends using a knife. Cut along full length with a knife. Turn Toe
Kick over, bend and then cut from front. Sand or scrape bottom edge
to remove rough patches.
WARNING!
Remove all sharp edges
23
To avoid a cutting hazard remove all sharp edges after trimming.
24
Remove Toe Kick tabs by snapping them off.
R
11