Table of Contents
Advertisement
2.1 L PITCHER
(Max Liquid Capacity: 2 L)
A
B
If your unit comes with this accessory, read the following instructions. For a list of what is included with this model, refer to inside flap of the box.
CAUTION: THE BLADE ASSEMBLY
IS NOT LOCKED IN PLACE. IF USING
THE POUR SPOUT, ENSURE THE
LID IS FULLY LOCKED ONTO THE
BLENDER PITCHER.
ASSEMBLY
ASSEMBLY:
OF THE 2.1 L
WARNING: NEVER LEAVE THE APPLIANCE
PITCHER
UNATTENDED WHILE IN USE.
(Max Liquid Capacity: 2 L)
CAUTION: USE CAUTION WHEN
HANDLING THE BLADE ASSEMBLY AS IT
NOTE: Ninja
Auto-iQ
®
®
IS VERY SHARP.
Technology can sense
which container is on the
IMPORTANT: MAKE SURE THE MOTOR
motor base. The function
BASE IS PLUGGED IN FOR USE.
lights will illuminate
1
Holding the Blade Assembly by the top of the
depending on which
shaft, place it onto the drive gear (A) inside the
container is placed on
pitcher. Ensure that the attachment is seated
the motor base.
properly and is standing upright.
NOTE: THE BLADE ASSEMBLY WILL FIT
LOOSELY ON THE DRIVE GEAR.
8
®
C
D
ASSEMBLY
CAUTION: THE BLADE
ASSEMBLY IS NOT LOCKED IN
PLACE. IF POURING WITH THE
LID REMOVED, ALWAYS REMOVE
THE BLADE ASSEMBLY FIRST.
2
Place the motor base on a clean, dry, level
surface such as a counter or tabletop. Press
down on the motor base to make sure the
suction cups adhere to the counter or tabletop.
3
Align and lower the pitcher (B) onto the motor
base. Handle should be aligned slightly to the
right of the LOCK symbol on the motor base.
4
Rotate the pitcher clockwise (C) until it locks in place
(you will hear a click when the lock is engaged).
5
The pitcher can be placed on the motor base
two ways; the handle can align with the front
right corner (D) or the front left corner (E).
6
Add the ingredients to the pitcher, making
sure they do not exceed the highest measured
marking line on the side of the pitcher.
w w w . s h a r k n i n j a m a n u a l s . c o m
E
F
IMPORTANT: DO NOT OVERFILL. TO AVOID
SPILLING, DO NOT ADD INGREDIENTS PAST
THE "MAX LIQUID" LINE.
NOTE: When blending any kind of liquids, such as
mixtures of any drinks or smoothies, do not exceed
the MAX LIQUID mark (2 L) on the pitcher.
NOTE: If you need to add additional ingredients
once the appliance is processing, turn the unit
OFF, open the pour spout cap, and pour the
ingredients in through the opening.
7
Holding the lid by the handle in the upright
position (F), place it on top of the pitcher
aligning the triangle ( ) located on the lid with
the triangle ( ) located on the pitcher handle.
Press the handle down until you hear a click.
8
The triangles on the lid and the pitcher handle
(G) MUST be aligned for the blender to turn on.
9
Plug the power cord into the electrical outlet.
The function lights will illuminate.
G
Advertisement
Table of Contents
