Samsung HG28EC690 Installation Manual page 32

Multi Code Remocon
¦
Multi Code Remocon is a special transmitter which is designed to control each TV with one remote.
This is useful where there is more than one TV in a location, such as in a hospital the set ID number is displayed in the
source osd. It is possible to support up to 9 different remote key transmissions for multiple codes.
Each TV has an initial code of "0".
– The ID code can be set and reset in Analog TV mode or PC mode. (not available in TTX channel or DTV channel.
– ID code can be from 0 to 9.
– Press the MUTE
number button to set the code.
– Set ID OSD appears.
– The following words appear: "Remote control code is set to 0. If you want to change Remote control code,
enter the chosen digit." X is the digit number.
✎ This OSD displays until Exit is pressed.
Remote control code is set to 0. If you want
to change the Remote control code, enter the
chosen digit.
– For example, TV and Remote will be set to ID code #1 if the user presses #1.
– The following words appear: "Remote control code is changed to 1" At this point, the TV can be controlled only
by the remote with the same ID code as the TV.
– TV, the following words will be displayed. " TV ID x"(x is the TV's ID)
– To reset the ID code, press the
When you stop pressing the buttons, the ID code for both the TV and Remote are reset to "0". "Remote
control code is set to 0." appears.
32
English
button and the RETURN
MUTE button and the
button simultaneously for more than 7 seconds and then select the
EXIT button simultaneously for more than 7 seconds.