Removing the G8264 from a Lenovo iDataPlex Rack
64
RackSwitch G8264 Installation Guide
This section describes how to remove the G8264 from a Lenovo iDataPlex rack.
To remove the G8264 from an iDataPlex rack, complete the following steps:
1. Disconnect all external cables.
2. If the 1U air duct option has been installed, remove it as described in
"Removing the 1U Air Duct Option" on page
3. Loosen and remove the M6 washers, screws, and clip nuts that attach the
alignment plate.
3
4. Loosen and remove the M6 washers and screws that mount the switch into the
rack.
3
5. Slide the switch out of the rack.
4
2
4
2
66.
8
10