Installing An Sfp+ Optical Transceiver - Lenovo RackSwitch G8264 Installation Manual

Installing an SFP+ Optical Transceiver

50
RackSwitch G8264 Installation Guide
4. Connect the fiber-optic cable following the
To remove an SFP optical transceiver, disconnect the fiber-optic cable, and pull
down the locking lever to release the transceiver. After you remove the transceiver,
replace the safety cap.
Approved 10 GbE SFP+ optical transceivers are supported in G8264 SFP+ ports
and in some breakout transceivers that can be installed in QSFP+ ports. The SFP+
optical transceiver provides two fiber-optic cable connectors for connecting to
external ports.
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
•
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
•
Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil À Laser de Classe 1
"Cabling Guidelines" on page 34.