Installing the power switch
1.
Insert the power switch into the slot and press it until it clicks into place.
2.
Route the power switch cable through the cable retention clip.
3.
Connect the power switch cable to the connector on the system board.
4.
Close the front bezel door.
5.
Install the:
•
bezel
•
cover
6.
Follow the procedure in
Removing the speaker
1.
Follow the procedure in
2.
Remove the:
•
cover
•
bezel
3.
Open the
front bezel
4.
To remove the speaker:
a. Disconnect the speaker cable from the connector on the system board [1].
b. Close the front bezel door.
c. Press the release tabs [2], and slide the speaker [3] and the speaker cable [4] out of the slot.
22
After Working Inside Your
Before Working Inside Your
door.
Computer.
Computer.