Installing the power supply unit (PSU)
1.
Insert the PSU into the PSU slot and slide it toward the back of the computer until it clicks into place.
2.
Tighten the screws to secure the PSU to the computer.
3.
Route the PSU cables through the retention clips.
4.
Connect the PSU cables to the connectors on the system board.
5.
Close the front bezel door.
6.
Install the:
•
bezel
•
cover
7.
Follow the procedure in
Removing the VGA card
1.
Follow the procedure in
2.
Remove the:
•
cover
•
bezel
3.
To remove the VGA card:
a. Remove the screws that secure the VGA connector to the computer [1].
b. Slide the VGA connector to release it from the computer [2].
c. Remove the screw that secures the VGA card to the computer [3].
d. Lift the VGA card using the handle to remove it from the computer [4].
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
19