Table of Contents
Advertisement
LAVA ROCK (4021-297): Place lava rock on the base pan and around the logs as shown in Figure 11. Use the supplied
burner tube slot cover to prevent the rock from going in between the base pan and burner. DO NOT allow any lava rock to
fall in the slot and onto the burner.
BURNER TUBE
SLOT COVER
LAVA ROCK
Figure 11. Lava Rock and Burner Tube Slot Cover
Note: When applying Lava Rock or Media in areas of the base pan that is covered by mesh, apply only one layer of
Lava Rock or Media.
RISK OF EXPLOSION!
• Place lava rock according to instructions.
• Do NOT place lava rock on burner top.
• Do NOT place lava rock in a position that they
may fall into area in front of pilot.
Remove the burner tube slot cover by removing the shipping screw on the back. Keep the burner tube slot cover and
screw in the lower cavity of the appliance. It will be needed for future cleaning of the logs and lava rock or servicing of
the appliance. Once the burner tube slot cover is removed, visually inspect the burner area to ensure that no lava rock is
present. See Figure 12.
Log #4 (2033-720): Log #4 is used twice in this log set. The right log is located by placing the "Y-Shaped" end on the flat area
of Log #1 and setting the other end on the right side Log #2. See Figure 10 and Figure 13. The log should be approximately
one inch from the end of the right side Log #2. See Figure 14.
1
Figure 13. Log #4 (1st of 2)
56
4
3
2
Heat & Glo • SL-5F, SL-7F Installation Manual • 2499-980 Rev. L • 10/19
NO LAVA ROCK IN BURNER SLOT
Figure 12. Burner Tube Slot Cover Removed
WARNING
• Use ONLY Hearth & Home Technologies-approved
optional media with this appliance.
• Do NOT use more than 3 pounds of lava rock per fireplace.
Improperly placed lava rock interferes with proper burner op-
eration.
Delayed ignition may occur.
1 IN.
Figure 14. Log #4 (1st of 2)
(INSIDE DASHED LINE)
Advertisement
Table of Contents
