Sony HT-XT3 Operating Instructions Manual page 26

 [Wireless Playback Quality]
You can set transmission data rate of
LDAC playback. This function is only
available when you set [Bluetooth
Mode] to [Transmitter] and [Bluetooth
Codec - LDAC] to [On].
[Auto]: The data rate is automatically
changed depending on environment. If
audio playback is unstable in this
setting, use other three settings.
[Sound Quality]: The highest data rate is
used. Sound is sent in the higher quality,
however audio playback sometimes
may become unstable when the link
quality is not good enough.
[Standard]: The middle data rate is
used. It balances both sound quality
and playback stability.
[Connection]: Stability is prioritized.
Sound quality may be reasonable and
connection status will most likely be
stable. If the connection is unstable, this
setting is recommended.
[System Settings]
 [OSD Language]
You can select the language you want
for the system on-screen display.
 [HDMI Settings]
[Control for HDMI]
[On]: Turns on the [Control for HDMI]
function. You can operate mutually
between device that are connected with
an HDMI cable.
[Off]: Off.
[Audio Return Channel]
This function is available when you
connect the system to a TV's HDMI IN
jack that is compatible with the Audio
Return Channel function and [Control
for HDMI] is set to [On].
26
US
[Auto]: The system can receive the
digital audio signal of the TV
automatically via an HDMI cable.
[Off]: Off.
[Standby Through]
You can output HDMI signals to the TV
even when the system is in standby
mode. This function is available when
you set [Control for HDMI] to [On].
[Auto]: Outputs signals from the HDMI
OUT (ARC) jack when the TV is turned on
while the system is in the standby
mode. This setting saves power in the
standby mode compared to the [On]
setting.
[On]: Always output signals from the
HDMI OUT (ARC) jack when the system is
in standby mode. If you connect a TV
other than "BRAVIA", we recommend
you to select this setting.
[Off]: No signals are output when
system is in standby mode. This setting
saves power in the standby mode
compared to the [On] setting.
 [Quick Start/Network Standby]
[On]: Shortens the startup time from
standby mode. You can operate the
system quickly after turning it on.
[Off]: The default setting.
 [Auto Standby]
[On]: Turns on the [Auto Standby]
function. When you do not operate the
system for about 20 minutes, the
system enters standby mode
automatically.
[Off]: Off.
 [Auto Display]
[On]: Automatically displays
information on the screen when
changing the audio signals, picture
mode, etc.
[Off]: Displays information only when
you press DISPLAY.