Remote Control Unit Installation Position - Sanyo SAP-K181A Technical & Service Manual

7-2. Remote Control Unit Installation
Position
The remote control unit can be operated from either a
non-fixed position or a wall-mounted position.
To ensure that the air conditioner operates correctly, do
not install the remote control unit in the following places:
In direct sunlight
Behind a curtain or other place where it is covered
More than 8 m away from the air conditioner
In the path of the air conditioner's airstream
Where it may become extremely hot or cold
Where it may be subject to electrical or magnetic
interference
Mounting on a Wall
a) Removable mounting
1) Momentarily hold the remote control unit at the
desired mounting position.
2) Confirm that the air conditioner responds
correctly when you press keys on the remote
control from that position.
3) After confirming correct operation, use a
screwdriver to screw the supplied special
mounting screw into the wall. (Fig.7a)
4) Hang the remote control unit from the mounting
screw.
b) Non-removable mounting
1) Momentarily hold the remote control unit at the
desired mounting position.
2) Confirm that the air conditioner responds
correctly when you press keys on the remote
control from that position.
3) After confirming correct operation, use a
screwdriver to screw the supplied special
mounting screw into the wall. (Fig.7a)
4) Remove the remote control cover by sliding it
downward.
5) Remove the batteries of the remote control unit.
6) Use a screwdriver to screw the remote control
unit securing screw into the wall through the hole
in the battery compartment. (Fig.7b)
7) Replace the batteries.
8) Again confirm that the remote control unit
operates correctly.
Removable mounting
Non-removable mounting
Screw
23
Wall
Special
mounting
screw
Fig.7a
Wall
Fig.7b