Drawing Up Bobbin Thread; Balancing Needle Thread Tension - Janome 2222 Instruction Manual

Janome 2222 Instruction Manual
1
2
3
e
q
w
www.toews.com
r
t
y

Drawing Up Bobbin Thread

z Raise the presser foot and hold the needle
thread lightly with your left hand.
x Turn the handwheel slowly toward you with
your right hand until the needle goes down
and continue turning the handwheel until the
take-up lever is at its highest position.
Lightly draw up the needle thread forming a
loop of the bobbin thread.
c Pull 10 cm (6˝) of both threads back and under
the presser foot.

Balancing Needle Thread Tension

z Correct tension
The thread tension is adjusted depending on
the sewing materials, layers of fabric and
sewing method.
For an ideal zigzag stitch, the bobbin thread
does not show on the right side (top side) of
the fabric, and the needle thread shows
slightly on the wrong side (bottom side) of the
fabric.
q Needle thread (Top thread)
w Bobbin thread (Bottom thread)
e Right side (Top side) of fabric
r Wrong side (Bottom side) of fabric
t Thread tension dial
y Setting mark
x Needle thread tension is too tight
When the bobbin thread (bottom thread) will
appear on the right side (top side) of the
fabric, Loosen the needle thread tension by
moving the dial to a lower number.
c Needle thread tension is too loose
When the needle thread (top thread) will
appear on the wrong side (bottom side) of the
fabric, tighten the needle thread tension by
moving the dial to a higher number.
2222 Owners Manual/ User Guide
20