Dual Rate; Battery Status; Factory Defaults; Fcc Details - Arrma ADX-10 BLX User Manual

Dual Rate

Factory Defaults

Steering/throttle channels switches set to 'N',
Steering and Throttle trim set to middle/zero adjustment.
Steering Dual Rate at 100%/fully right.
Electronic Speed Controller (ESC)
If using LiPo batteries you must set the correct battery mode on the ESC (electronic
speed controller) to prevent battery damage.
ESC Specifications
Input Voltage 6-8 NiMh (7.2-9.6v) / 2S/3S LiPo (7.4-11.1v)
Deans® battery
connector
Motor wires
x 3
Power capacitor
HEAT-SINK MAY BE HOT AFTER USE

Throttle Setup

Do not move the throttle when switching the model on and the ESC will automatically set the throttle neutral. A long beep
will sound to confirm setup.
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.

Battery Status

Contains FCC ID: ZL4-KST-HXGT2
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions: (1)
this device may not cause harmful interference, and
(2) this device must accept any interference received;
including interference that may cause undesired
operation.
BEC Output
Receiver Plug (CH2)
7
If battery status LED is flashing,
the batteries need to be replaced.
6.0v/2A Max
Power Switch & Set
button
Heat-sink and Fan
WWW.ARRMA-RC.COM