Servo Removal - Arrma ADX-10 BLX User Manual

Steering Access (cont.)
5
Disconnect servo arm ball-joint and remove steering
assembly from servo box.

Servo Removal

Tools Required
1
Access the receiver (page 25); unplug the steering servo
wire (CH1) and remove the wire from the receiver box.
3
Disconnect the steering ball joint and lift the servo
assembly from the chassis.
DESIGNED FAST. DESIGNED TOUGH.
6
2mm Hex Driver
Throttle
(CH2)
Steering
(CH1)
26
Inspect servo saver, ensuring that it is set to the
factory setting above. Set with 7mm hex driver.
Reassembly is the reverse the removal process.
ARRMA-RC.COM/
Upgrading your servo will give quicker
SUPPORT/
and more powerful steering.
2
Remove the two servo box cover bolts with a
2mm hex key and remove the cover.
4
Note mount spacing and servo arm position.
Remove mount and arm bolts with a 2mm hex key.
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
4mm