Configuration; Smart Wizard Configuration; Ip Information; Password - D-Link DGS-1210-20 Reference Manual

4 Configuration

4
Configuration
The features and functions of the D-Link Web Smart Switch can be configured for optimum use through the
Web-based Management Utility.

Smart Wizard Configuration

After a successful login, the Smart Wizard will guide you through essential settings of the D-Link Web Smart
Switch. If you do not plan to change anything, click Exit to leave the Wizard and enter the Web Interface.
You can also skip it by clicking Ignore the Wizard next time for the next time you logon to the Web-based
Management.

IP Information

IP Information
will guide you to do basic configurations in 3 steps for the IP Information, access password, and SNMP.
Select Static, DHCP or BOOTP, and enter the desired new IP Address, select the Netmask and enter the
Gateway address, then click the Next button to enter the next Password setting page. (No need to enter IP
Address, Netmask and Gateway if DHCP and BOOTP are selected.) The Smart Wizard is for the quick
setting in IPv4 environment. For IPv6 network, please go to
changing the settings, click Exit button to go back to the main page. Or you can click on Ignore the wizard next time to
skip wizard setting when the switch boots up

Password

Type the desired new password in the Password box and again in the Confirm Password, then click the
Next button to the SNMP setting page.
.
Figure 4.1 – IP Information in Smart Wizard
NOTE: The Smart Wizard supports quick settings
for IPv4 network.
14
D-Link Web Smart Switch User Manual
System > IPv6 System Settings.
If you are not