Table of Contents
Advertisement
Camera
Front
Lens
This is a 30-magnification optical zoom lens.
Infrared remote commander sensors
These are sensors for the supplied infrared remote
commander.
POWER lamp
Lights in green when the camera is connected to an AC
outlet using the supplied AC power adaptor and AC power
cord.
Flashes in green when the camera receives an operation
command from the supplied infrared remote commander.
When the power is turned on, it takes about 15 to 30
seconds to display the image after the lamp lights.
STANDBY lamp
Lights in amber when the power is turned off using the
infrared remote commander.
Locations of Controls
Rear
Infrared remote commander sensors
These are sensors for the supplied infrared remote
commander.
IMAGE FLIP switch
Flips the image upside down. Normally set this to OFF when
you use the camera. When the camera is attached to the
ceiling, set this to ON. Turn off the unit before setting the
IMAGE FLIP switch. Then, turn the power on by
connecting the power adaptor, by VISCA CONTROL or the
infrared remote commander. When you switch IMAGE
FLIP, the preset setting is returned to the initial setting.
VISCA RS-422 connector
To communicate via RS-422, use this connector.
Use the supplied VISCA RS-422 connector plug.
Hide quick links:
Advertisement
Table of Contents
