Table of Contents
Advertisement
E. Glass Rock Media Kit
WARNING! Choking Hazard! Keep glass rock media
out of reach of children.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
Cleaning the Glass Rock Media
During shipment of the glass rock media, dust and debris
can accumulate in the rock bag. It is recommended that
the glass rock media be rinsed thoroughly with water to re-
move dust and small glass rock particles. An easy method
to clean the glass rock media is to empty the contents of
the bag into a bucket and rinse thoroughly with a garden
hose. Allow the glass rock media to dry before installing
into the fireplace.
Installation
1. Place glass rock media evenly on base pan and over
top of burner. Do not block the open area by the glass
refractory. This area must remain open for proper air
flow. See Figure 9.6.
WARNING
Delayed Ignition Risk
• Place glass rock media according to instructions.
• Do NOT place glass rock media in area in front
of pilot.
• Do NOT place glass rock media in a position that they may
fall into area in front of pilot.
• Do NOT use any media other than the glass rock media
supplied with this fireplace.
Fireplace will not function properly.
Delayed ignition may occur.
NOTICE: Care should be taken to avoid placing glass rock
media between the left and right of the media tray and the
firebox. Blocking this gap may cause an undesirable flame
appearance. See Figure 9.6.
Figure 9.6 No Glass Rock Media in Gap
2. Remove the screw that holds the rock placement jig in
place. Carefully remove the rock jig, making sure that
no media falls into the pilot area.
Outdoor Lifestyles by Hearth & Home Technologies • TWILIGHT-II-MDC Installation Manual • 2369-970 Rev. L • 8/19
NO MEDIA IN SHADED AREA
(BOTH LEFT AND RIGHT SIDE)
WARNING! Risk of explosion! DO NOT place glass rock
media directly in front of the pilot assembly or between the
burner tracks over the burner ports. Improperly placed
media may interfere with proper burner operation.
Figure 9.7 Rock Placement Jig
CORRECT
NO MEDIA IN PILOT AREA
Figure 9.8 CORRECT Media Placement
INCORRECT
MEDIA IN PILOT AREA NOT ALLOWED
Figure 9.9 INCORRECT Media Placement
F. Appliance Start Up
After appliance is completely set up, replace glass
assembly (assemblies). Start the appliance and perform
a leak check using a commercially available, noncorrosive
leak check solution. Be sure to rinse off all leak check
solution following testing. Extinguish the pilot and turn
the appliance off.
G. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to the
model).
33
Advertisement
Table of Contents
