Installing The Camera On A Surface; Step 1: Drill The Holes - LevelOne FCS-3056 Hardware User Manual

Installing the Camera on a Surface

This section describes the procedures in installing the camera on a flat surface such as a hard or
dropped ceiling and straight or tilted walls. Before installation, make sure the wall or the ceiling
can bear more than the weight of the camera.
NOTE: The camera images on the suceeding pages may slightly vary from the actual camera.

Step 1: Drill the Holes

Before drilling the holes on the ceiling or wall, note the direction of the connectors side of the
camera, which is also the opposite side of the camera logo. This influences the camera
placement and where you should drill the hole where the cables will pass through or how the
cables will go along the ceiling or wall.
1. Use the supplied drill template to mark the screw holes on the surface according to the
preferred orientation.
2. Determine how the cables will be routed: pass through the surface or along the surface.

If the cables will pass through the surface, drill the cable hole and the three (3)
screw holes on the surface.
Cable hole

If the cables will be routed along the surface, just drill the three (3) screw holes on
the surface.
3. Insert the plastic plugs into the screw holes.
Hardware Manual
14