Charging Battery Pack; Fcc Caution - Bosch FL11 Operating/Safety Instructions Manual

BM 2610022017 04-12_BM 2610022017 04-12.qxp 4/17/12 12:45 PM Page 6
If the red indicator light is "ON",
the battery pack is too hot or
cold for fast-charging. The
charger will switch to trickle charge, until a
suitable temperature is reached, at which
time the charger will switch automatically to
fast-charging.

CHARGING BATTERY PACK

(BC430 30 MINUTE CHARGER)
The lithium ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty,
the cordless worklight is switched off by
means of a protective circuit.
Do not continue to press the
CAUTION
On/Off switch after the
cordless worklight has been automatically
switched off. The battery can be damaged.
The battery is supplied partially charged.
Completely charge the battery before using
your cordless worklight for the first time. The
lithium ion battery can be charged at any
time, without reducing its service life.
Interrupting the charging procedure does not
damage the battery.
Plug charger cord into your standard power
outlet, then insert battery pack into charger
(Fig. 2).
FIG. 2
RED GREEN
LIGHT LIGHT
contacts of the charger or battery pack are
contaminated. Clean the contacts of the
charger or battery pack only as directed in
these operating instructions or those supplied
with your tool or battery pack.
The charger's green indicator light will begin to
"BLINK". This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery pack is
fully charged.
When the indicator light stops "BLINKING"
(and becomes a steady green light) fast
charging is complete.
The battery pack may be used even though
the light may still be blinking. The light may
require more time to stop blinking depending
on temperature. When you begin the
charging process of the battery pack, a
steady red light could also mean the battery
pack is too hot or too cold.
The purpose of the green light is to indicate
that the battery pack is fast-charging. It does
not indicate the exact point of full charge.
The light will stop blinking in less time if the
battery pack was not completely discharged.
When charging several batteries in sequence,
the charge time may slightly increase.
BATTERY
When the battery pack is fully charged,
PACK
unplug the charger (unless you're charging
another battery pack) and slip the battery
pack back into the tool.
CHARGER
The manufacturer is not responsible for radio
interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user's authority
to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful
2) This device must accept any interference
-6-
If the red indicator light is
"BLINKING", the battery pack
cannot accept a charge or the

FCC Caution:

interference, and
received, including interference that may
cause undesired operation.