Installing The Pci-E Add-On Card; Figure 3-7. Installing A Hard Drive In A Carrier - Supermicro SBI-7426T-SH User Manual

SBI-7426T-SH Blade Module User's Manual
3-7

Installing the PCI-E Add-on Card

The SBI-7426T-SH blade module contains a single slot for a PCI-E 2.0 x16 add-on card.
Your add-on card uses a riser card that allows the add-on card to be properly installed
parallel to the blade module's mainboard. There is also cover shield that you must
attach to the add-on card in order to maintain proper air flow to the blade module.
Use the procedure below to install the add-on card to the blade module.
Installing an Add-on Card to the Blade Module
1. Remove the chassis cover from the blade module.
2. Attach the add-on card bracket to the add-on card cover shield

Figure 3-7. Installing a Hard Drive in a Carrier

3-12
(Figure 3-8).