Table of Contents
Advertisement
4: Hardware and Software Installation
• Installation overview
• Install the MP
modem
Note: The MP modem is
designed for negative-
ground vehicles only. It will
not function in a positive-
ground vehicle.
Rev 1.0 Apr.10
This chapter provides instructions for installing the MP modem,
installing the AceView software, and activating your account.
The MP modem installation should be done by a professional.
Before you begin the installation, ensure that you have all the
necessary components and equipment listed and have read the
"Installation overview" section below.
Installation overview
The MP modem may be installed in a vehicle (typically the trunk) and
connected to a laptop computer mounted on the dashboard (as
shown in the following illustration) or in an office.
MP modem
Figure 4-1: Installation of the MP modem in a vehicle equipped with a notebook
computer and a combination antenna, using the car battery for power and ignition-
sense wiring for power on/off.
MP modem housing
The MP modem has a rectangular metal housing. There is a
connector panel on the rear, an indicator panel on the front of the
housing, a reset button on top, and mounting holes along the bottom
edges on either side.
Main RF/GPS
antenna
4
21
Advertisement
Table of Contents
