Table of Contents
Advertisement
Note: If GPS is being
implemented, you require
either two antennas or a
combination Main RF and
GPS antenna.
Note: Do not connect the
MP modem to a USB port
on a computer before
installing the software.
Rev 1.0 Apr.10
· The Ethernet cable should have RJ-45 connectors. The MP modem's
performance is affected by the type of Ethernet card in the computer and
the type of cable used. The minimum requirement for the Ethernet cable is
an unshielded twisted pair (UTP) cable, category 3 or 4. For better perfor-
mance, use a shielded, category 5 cable. The maximum length is 100 m
(328 feet).
•
Main Radio frequency antenna and cable.
appropriate regulatory approval, 50 ohm impedance, and a male TNC
connector. It may be a hard or magnetic-mount antenna.
•
Access Point antenna and cable. (MP895 WiFi modem
antenna is an RP (reverse-polarity) male SMA connector.
•
GPS antenna and cable (optional).
GPS module.
•
Power supply.
This is usually the vehicle's battery.
•
Appropriate electrical grounding.
16-gauge wire and connect it to a ground screw.
•
I/O cable (optional).
other I/O device is installed.
System requirements
Before you begin the installation, ensure your computer meets the following
system requirements necessary for the installation and running of AceView
software:
•
Operating systems:
®
™
· Windows
Vista
· Windows XP (Home or Professional)
•
Available USB, Ethernet, or DB9 serial port
•
CD-ROM drive (installation only)
•
32 MB RAM memory
MP modem accessories
For information about accessories for your MP modem— including cables and
antennas—contact your account manager or visit www.sierrawireless.com.
This is necessary if you use the built-in
If a ground wire is necessary, use a
This is required if a panic button, sensor, gauge, or
Getting Started
The antenna must have the
only).The WiFi
17
Advertisement
Table of Contents
