Table of Contents
Advertisement
3: Activating your MP on your cellular
provider network
•
Configure your
account
Note: Ensure that the MP
modem and your computer
are powered off while
installing cables.
Rev 1.0 Apr.10
Configure your account
1. Install the USB, Ethernet or serial cable
To install the USB, Ethernet, or serial cable, thread the cable through
the vehicle and attach it to the USB, Ethernet, or serial connector on
the MP modem.
Note: Do not connect the cables to the computer until you have installed the
software.
The MP modem has a SIM card slot next to the lights on the indicator
panel. The slot is protected by a removable rubber cover, and houses
a SIM card sled. To insert a SIM card into the MP modem:
2. Open the rubber cover.
3. Use a pen or stylus to press the yellow eject button inside the
slot.
4. Pull the sled out of the slot.
5. Place the SIM card into the sled until it clicks into place. The SIM
card should fit in only one way, with the contact surfaces facing
up as shown.
Figure 3-1: Placing a SIM card into the sled.
3
19
Advertisement
Table of Contents
