Paper Ribbon Sensor Test - ELCOM Euro-50TE Mini User Manual

Procedure for initiating the test:
Sequence of steps
In the P-mode, press
menu for testing the position of the thermal printer head (P-mode
– Sys. parameter – Tests):
Confirm by pressing
display will show:
If the printer head is lifted, the display will show:
Complete the test by pressing

Paper ribbon sensor test

The display will show the current state of paper ribbons present in the sensors. Installing and removing
paper from the sensors changes the status depicted on the display, depending on the presence of the
paper in the sensor.
Procedure for starting the test:
Sequence of steps
In the P mode, use the
menu pre test to enter the menu for testing the paper ribbon sensor
(P-mode – Sys. parameter – Tests):
Confirm by pressing
inserted in the printer, this will appear on the display:
If there is an error in one of the thermal papers, the display will show
Complete the test by pressing
 
or and press

TOTAL . If the printer head is in place, the

TOTAL .
 
or buttons and press

TOTAL . If both thermal ribbons are correctly

TOTAL .

TOTAL to enter the

TOTAL do
Helpful advice
Display
Tests
Head position
Head OK
Head raised
Test OK
Display
Tests
Paper ribbons
Paper OK
žurnal OK
Paper OK
Žurnal error
Test OK
81