Flanders Scientific LM-0750W User Manual page 19

Video Menu (continued)
Video Menu Organization
Main Menu
Function
Scopes & VU-Meters
Video
Audio
Marker
System
Alarm
OSD
GPI
Display Alignment
System Status
Support
Video Menu Functions
Signal Mode
Selecting 'Film' for this option allows the monitor to compensate for material with 2:3 pulldown to provide a
smoother image. Selecting 'TV' for this option processes the incoming video signal with no 2:3 pulldown
compensation. Selecting 'Auto' will automatically trigger 'Film' mode anytime 2:3 pulldown is detected.
Processing
The Processing function has three options: Normal, Fast, & Noise Reduction. In Normal mode the monitor
will display interlaced video as interlaced and have a very low latency processing delay. In Fast mode the
video processing delay is further improved to provide the lowest possible processing latency, but ancillary
functions and menu displays are updated more slowly. In Noise Reduction mode video processing delay is
increased to allow for additional noise reduction processing and the monitor will deinterlace the signal and
display it as progressive
Composite Setup
Allows you to toggle between 0 or 7.5 IRE setup selection for composite sources.
Component Setup
Using the Component Setup feature allows you to specify what type of component signal you are sending to
the monitor. Select from YPbPr SMPTE/N10, YPbPr Betacam, YPbPr MII. Your selection will automatically
adjust the monitor to compensate appropriately for differences in saturation and setup defaults within these
standards. Please note that you can override the setup selection set by this Component Setup feature by
toggling the Composite Setup function after selecting the desired Component Setup default.
SDI Format (ONLY APPLIES TO 3Gbps SDI ENABLED MONITORS)
FSI Monitors are capable of detecting the payload ID contained in an SDI signal and adjusting the format ac-
cordingly. However, some sources or upstream equipment may not generate or pass this payload ID. For
sources lacking a proper Payload ID you may override the SDI Format auto detect function and manually
choose between the following formats: 4:2:2 YCbCr, 4:4:4 YCbCr, 4:4:4 RGB, 4:4:4 YCbCr 12bit, 4:4:4 RGB
12 bit, 4:4:4 XYZ 12bit, or 4:2:2 YCbCr 12 bit. It may be necessary to force the monitor to re-sync to a signal
when changing formats at the source even when set to AUTO. You can force the monitor to re-sync by either
reselecting AUTO from the SDI Format menu, selecting the appropriate format manually from the SDI Format
Menu, or simply toggling to another input and back to the input in use. Please note that on monitors with a
selectable color space option that XYZ signals will be mapped to the color space selected on the Display
Alignment menu. The SDI Format toggle only applies to 3Gbps SDI signals. Please note that if you put the
monitor into XYZ mode manually it is important to switch this setting back to AUTO if you intend to monitor
other signal types on any input, failing to do so will result in an incorrect display of other signal formats.
Video
Gamma Select
Log Mode
Color Temperature
Sharpness Level
SD Enhancement
Anamorphic De-Squeeze
Signal Mode
Processing
Composite Setup
Component Setup
SDI Format
Gamma 2.2
Off
6500K
Default
Off
4:3
Auto
Normal Mode
7.5 IRE
YPbPr SMPTE/N10
Auto
19
Back to Table of Contents
© 2012 Flanders Scientific, Inc.