Table of Contents
Advertisement
air supply. Check for adequate ventilation around machine
6.
Erratic cut – Torch spitting when cutting
Check torch consumables and replace if necessary as per instructions earlier in this
manual
Check if correct amperage for thickness of metal, if to slow travel speed or to much
cutting power, increase speed of cut or reduce cutting amperage. (When machine
senses no metal left to cut it will switch of main cutting power and switch on HF pilot
arc, this is the HF pilot arc restart)
Water contamination in torch head, Check for water in water trap at rear of machine, if
water is present, drain air compressor, clean water out of air lines, empty water trap by
pressing water release button on bottom of air regulator water trap. Fit new
consumables as per instructions earlier in this manual
Plasma Torch Consumables parts list
R-Tech Torch Spares
Plasma 80HF
Electrode
Cutting Tip 1.0mm 40 Amp
Ceramic Cup
Spring, Stand off
Torch Head –Hand Held
Torch Complete Hand Held 6M
Plasma 60,80,100 HF
Electrode
Cutting tip 0.8mm 30 Amp
Cutting tip 1.1mm 60 Amp
Cutting tip 1.3mm 80 Amp
Cutting tig 1.5mm 100 Amp
Shroud
Torch Head hand held
Torch Head Machine
Torch Complete 6m Hand Held
Torch Complete 6m Machine type
16
Part No.
P40-EL
P40-CT1
P40-CC
P40-SS
P40-THH
P40-6MHHT
P60100-EL
P60100-CT08
P60100-CT11
P60100-CT13
P60100-CT15
P60100-SH
P60100-THH
P60100-THM
P60100-6MHHT
P60100-6MMTT
Advertisement
Table of Contents
