Forward-Facing Installation With Latch - Graco PD265358C Owner's Manual

FORWARD-FACING INSTALLATION WITH
Adjust child restraint to Upright position
(fig. a). Flip recline feet out for
forward facing use. Make sure Rear Facing
LATCH belt is stored. (see fig. b, pg. 41)
Place forward-facing on vehicle seat
equipped with LATCH anchors.
For ease of installation, extend LATCH
belt to its maximum length.
Hook connectors to vehicle lower
anchors (fig. b). Belt must lay flat and
not be twisted. Pull connectors to be
sure they are securely attached (fig. c).
Slide child restraint back until the
estraint is in contact with the vehicle
seat back.
Press down firmly in center of child restraint
to compress vehicle seat cushion while
tightening LATCH belt by pulling adjustment
belt (fig. d).
Pull front to back and left to right at belt path
to check for secure installation (fig. e).
Check that the lower anchor belt stays tight
and does not slip from the tightened position.
If it does not stay tight, try another seating
position or contact Customer Service.
Attach tether strap hook (A) to anchor
hardware (B) and tighten adjustment belt to
remove any slack (fig. f). Belt must lay flat and
not be twisted.
Periodically check that child restraint is securely
installed; adjust if necessary.
• NOTE: Some vehicle manufacturers have lower
maximum weight ratings for
must consult your vehicle owner's manual or call the
vehicle manufacturer to confirm the limits on your
vehicle's LATCH anchors.
• To remove LATCH, (see "Removing
Vehicle Anchor Points", p. 40).
20
LATCH
LATCH anchors, so you
LATCH from