Technical Information - Zanussi ZWG 6148K User Manual

Problem
The appliance fills with
water and drain immedi-
ately.
The washing results are
not satisfactory.
After the check, activate the appliance. The
programme continues from the point of inter-
ruption.
If the problem occurs again, contact the Serv-
ice.
Service
We recommend the use of original spare parts.

Technical information

Dimensions
Electrical connection:
Level of protection against ingress of solid particles and moisture en-
sured by the protective cover, except where the low voltage equipment
has no protection against moisture
Water supply pressure
1)
Water supply
Maximum load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
16
Make sure that the packaging and/or the transit bolts are removed. Refer to 'Instal-
lation instruction'.
Add more laundry in the drum. The load may be too small.
Make sure that the drain hose is in the correct position. The end of the hose may
be is too low. Refer to 'Installation instruction'.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Maximum
Possible solution
When contacting the Service, make sure that
these data are available. You can find the infor-
mation on the rating plate: model (Mod.), PNC
(Prod.No.), Serial number (Ser.No.).
600 / 850 / 501 mm
519 mm
230-240 V
2100 W
13 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
6 kg
1400 rpm
www.zanussi.com