Zanussi ZWG 6148K User Manual page 15

Problem
The appliance does not
fill with water.
The appliance does not
drain the water.
The spin phase does
not operate
or
the washing cycle lasts
longer than usually.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes an
unusual noise.
www.zanussi.com
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the household fuse box.
Make sure that the button Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the end of the countdown.
Make sure that the programme knob is in the correct position.
Deactivate the Child Lock function if it is on.
Make sure that the water tap is opened.
Make sure that the pressure of the water supply is not too low. For this informa-
tion, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of the valve are not clogged.
Refer to 'Care and cleaning'.
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose is correct.
Make sure that the sink spigot is not clogged.
Make sure that the water drain hose has no kinks or bends.
Make sure that the connection of the water drain hose is correct.
Set the drain programme if you set a programme without the drain phase.
Set the drain programme if you set an option which ends with water in the drum.
If above mentioned solutions do not help, contact the Service (as the filter of the
drain pump may be clogged).
Adjust manually the items in the drum and start the spin phase again. This problem
may be caused by balance problems.
Set the spin programme.
Set the drain programme if you set an option which ends with water in the drum.
If above mentioned solutions do not help, contact the Service (as the filter of the
drain pump may be clogged).
Make sure that the couplings of the water hoses are tight and there are no water
leakages.
Make sure that the water inlet hose and the water drain hose has no damages.
Make sure you use the correct detergent and the correct quantity of it.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the drum.
Make sure that the leveling of the appliance is correct. Refer to 'Installation in-
struction'.
Possible solution
15