Troubleshooting - Zanussi ZWG 6148K User Manual

1.
1
2
3
3.
Frost precautions
If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the
drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Remove the drain hose from the rear
support and unhook it from sink or spigot

Troubleshooting

The start of the appliance does not occur or the
appliance stops during operation.
First try to find a solution to the problem (refer
to the table). If not, contact the Service.
During appliance operation it is possible that
the red indicator of button Start/Pause flashes
and one of the indicators comes on, to show
that the appliance does not operate:
Problem
The appliance does not
start.
14
2.
4.
45°
20°
Make sure that the mains plug is connected in the mains socket.
5. Put the ends of the drain and inlet hose
in a container. Let the water flow out of
the hoses.
6. When no more water flows, install the in-
let hose and the drain hose again.
Warning! Make sure that the temperature
is more than 0 °C before you use the
appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
• Washing : the appliance does not fill with
water.
• Extra Rinse : the appliance does not drain
the water.
• End : the appliance door is open or not
closed correctly.
Possible solution
www.zanussi.com