Preparation Of Top Cabinet; Adjust Blower Motor - GE AVM4160 Installation Instructions Manual

B2 USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
Read the instructions on the TOP CABINET TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
B3

ADJUST BLOWER MOTOR

Remove the screws holding the blower unit and
1
the screws securing the blower plate. Remove
the blower plate from the outer case by sliding it
toward the back of the microwave and pulling up.
Blower Motor Screws
2 Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
Installation Instructions
Blower Plate
Blower
Motor
Screw
18
B3
Rotate 90°
Roll the blower so that fan blade openings are
3
facing the top of the oven. Place the blower back
into the opening.
Fan Blades
Wires
Note: Make sure the wires remain routed through the
openings in the motor frame. To avoid damage to
the fan motor wiring, insert motor carefully such that
the fan motor wiring does not contact the microwave
power cord bracket.
WARNING:
Can cause injury or death. Do not pull or stretch the
pinched.
4 Slide the blower plate back onto the microwave
by placing the side tabs into the slots and pushing
gently until the back tab is seated into the rear slot.
Replace 3 screws.
Side Tab
Side Slot
Back of
Mircrowave
Back of
Mircrowave
Rear Tab
Rear Slot