Sanyo PLC-XU105 Owner's Manual page 48

Setting
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a certain
period.
If the input signal is interrupted and no button is pressed for
more than 30 seconds, the timer display with "No signal"
appears. It starts the countdown until the lamp is turned off.
◄►
Use the Point buttons to set the countdown timer.
Select one of the following options:
Ready .................. When the lamp has been fully cooled down,
the POWER indicator changes to green
blinking. In this condition, the projection
lamp will be turned on if the input signal
is reconnected or any button on the top
control or remote control is pressed.
Shut down............ When the lamp has been fully cooled down,
the power will be turned off.
Off ........................ Power management function is off.

Note:
• Factory default is "Ready: 5 min.".
On start
When this function is set to "On," the projector will be
automatically turned on just by connecting the AC power
cord to a wall outlet.

Note:
• Be sure to turn off the projector properly (see "Turning
Off the Projector" on page 20). If the projector is turned
off in the incorrect sequence, the On start function does
not work properly.
48
Power management
Time left before Lamp is off.
Press the SELECT button at
Power management and this
dialog box appears. Use the
Point
one of the three options.
Press the Point
select the timer, and then
use the Point
set timer.
◄►
buttons to choose
▼
button to
◄►
buttons to