Table of Contents
Advertisement
Dubbing/Importing
Dubbing Still Images from
the HDD
Still images stored in the internal HDD can be dubbed to a
BD-RE or an SD card as follows.
Memo:
Only "JPEG" still image format is supported.
For more details, refer to "Dubbing the picture data from the
HDD" (A page 26) .
Before dubbing
Dubbing to a disc
Set the BD-RE for dubbing on the disc tray
Dubbing to an SD card
Insert the SD card to be dubbed into the [SD SLOT]
Dubbing still images
1 Press the [DUBBING] button on the remote
control unit
The Dubbing menu screen appears.
2 On this screen, select "DISC/SDiPICTURE"
3 Select the media to dub to from the media
selection screen
A checkmark will be added to the selected media.
44
4 Select "NEXT", and press the [OK] button
Memo:
A message appears on the monitor when dubbing cannot
be performed in the following cases. When this occurs,
replace the disc or SD card with one that is usable.
When an incompatible disc or SD card is set
When there is insufficient space on the set disc or SD
card
When an unformatted disc or SD card is set
For details, refer to "Formatting a disc" (A page 27) or
"Formatting an SD Card" (A page 29) .
5 Select the still images to dub, and press the
[MARK] button
Pressing the [MARK] button adds a check mark to the
selected image.
All still images with a check mark are dubbed.
Memo:
To clear the check mark, select the corresponding still
image, and press the [MARK] button.
Pressing the [OPTION] button displays a pop-up menu.
The pop-up menu enables you to perform the following
operations.
: Exits the pop-menu and returns to the
BACK
initial screen.
: Selects all still images within the same
SELECT ALL
group.
DESELECT ALL : Clears the selection of all still images
within the same group.
Note:
A message appears if the selected still images do not fit
into the disc. Check mark cannot be added to a still image if
there is insufficient space on the disc.
Advertisement
Table of Contents
