Connecting The Wol Cable - D-Link dge-530t User Manual

Section 3 - Advanced Features
NOTE:.If.your.system's.motherboard.WoL.Connector.does.not.fit.the.WoL.Cable.or.does.not.have.3.pins,.do.not.attempt.
to.force.a.connection.or.alter.the.components.to.fit..Doing.so.could.permanently.damage.your.computer.
The WoL function is system dependent, in addition to the following instructions, you may need to download WoL software
from INTEL or another manufacturer's website.
Please consult your computer's manual for specific BIOS settings.
The WoL Cable is an interconnect cable with standard 3-pin connectors on each end. Please follow the procedures listed below
to ensure proper installation of the WoL cable.
1. Connect either end connector of the WoL Cable to the adapter's WoL Connector. Both ends of the WoL Cable
are identical, so either end may be used.
Examine the PC motherboard and/or refer to the manual for the motherboard to locate the corresponding WoL
Connector on the motherboard. The actual location is system dependent, but the motherboard may have a
label beside the WoL Connector. After you have located the WoL connector on the motherboard, connect the
cable.
2. Power-ON the PC and press "Delete" or "F1" when prompted to enter the PCI/ISA BIOS CMOS Setup. Enable the
WoL function or the power-ON function of the PC.
The name of this function is system dependent, but may be located in a category heading titled something like
Power Management. Refer to your computer's manual for more information regarding the CMOS Setup Utility
and BIOS settings.
D-Link DGE-530T User Manual

Connecting the WoL Cable

24