Sharp LC-19SB15U, LC-19SB25U, LC-19SB25U-W Operation Manual page 24

Basic adjustment settings
Channel memory setting
Press MENU to display the MENU screen, and
1
then press c / d to select "Setup".
Press a / b to select "CH Setup", and then
2
press ENTER.
Press a / b to select "CH Memory", and then
3
press ENTER.
Press ENTER.
4
When viewing ANALOG broadcasts:
5
1 Press c / d to select the channel to skip,
and then press b to move down.
2 Press c / d to select "On", and then press
ENTER.
• On: Skips channels. (Channel selection disabled
using CH r / s .)
• Off: Does not skip channels. (Channel selection
enabled using CH r / s .)
When viewing DIGITAL broadcasts:
1 Press a / b to select the channel to skip,
and then press ENTER to select "ADD" or
"ERASE".
• ERASE: Skips channels. (Channel selection
disabled using CH r / s .)
• ADD: Does not skip channels. (Channel selection
enabled using CH r / s .)
Press MENU to exit.
6
• Make sure what kind of connection is made with your TV.
Antenna Setup Digital
In order to receive digital air broadcasts, you need
a digital broadcast antenna. You can confi rm the
antenna confi guration through the "Antenna Setup
DIGITAL" screen.
If necessary, adjust the direction of the antenna to
obtain the maximum signal strength.
Signal Strength
Press MENU to display the MENU screen, and
1
then press c / d to select "Setup".
24
This manual downloaded from http://www.manualowl.com
Press a / b to select "CH Setup", and then
2
press ENTER.
Press a / b to select "Antenna Setup Digital",
3
and then press ENTER.
Press a / b to select "SIGNAL STRENGTH".
4
• The signal strength of DIGITAL channel is
displayed. The signal information is based on the
current channel.
SIGNAL STRENGTH
CHANNEL STRENGTH
Press MENU to exit.
5
• This "SIGNAL STRENGTH" display is a standard to decide
the best direction of the antenna, and cannot to guarantee
image/voice.
Channel Strength
Press MENU to display the MENU screen, and
1
then press c / d to select "Setup".
Press a / b to select "CH Setup", and then
2
press ENTER.
Press a / b to select "Antenna Setup Digital",
3
and then press ENTER.
Press a / b to select "CHANNEL STRENGTH",
4
and then press ENTER.
-digit channel number to check
• Input the 2
the strength of the selected channel.
• Make sure the appropriate signal strength of each
channel received is obtained.
SIGNAL STRENGTH
CHANNEL STRENGTH
Press MENU to exit.
5
Adjust the antenna until
the level is 60 or higher
str