Reviewing The Most Recently Recorded Scene (Last Scene Review) - Sony NEX-FS100U Operating Manual

To record with the Slow & Quick
Motion function
Press the S&Q button A, then the START/
STOP button.
Recording starts.
To stop Slow & Quick Motion
recording
Press the START/STOP button again.
To change the frame rate setting
Hold the S&Q button A down for about 1
second, than change the value with the
SEL/PUSH EXEC dial.
Holding the S&Q button A down again for
about 1 second restores the previous setting.
To cancel Slow & Quick Motion
recording
Press the S&Q button A or the MENU
button C during standby.
z Notes
• When you are recording with a slow frame rate,
the camcorder may continue recording for a few
more seconds after you press the START/STOP
button to stop recording.
• You cannot change the frame rate during Slow
& Quick Motion recording. To change the frame
rate, stop current Slow & Quick Motion
recording.
• The time code is recorded in the [REC RUN]
mode during Slow & Quick Motion recording
(p. 78).
• The Slow & Quick Motion mode is canceled
automatically when the POWER switch is set to
OFF, but the frame rate setting is retained.
• You can record sound only at 100% (standard).
• You cannot use the Slow & Quick Motion
function for the simultaneous recording.
• You cannot use the Slow & Quick Motion
function with the standard image quality (SD).
Reviewing the most recently
recorded scene (Last Scene
Review)
You can review the most recently recorded
scene on the screen.
Right after you stop recording, press
the LAST SCENE button.
The camcorder plays from the top to the
end of the most recently recorded scene,
then returns to standby mode.
To stop reviewing the last scene
Press the LAST SCENE button during
playback. The camcorder returns to standby
mode.
z Notes
• If you edit the movie or remove the recording
media after you stop recording, the Last Scene
Review function may not work correctly.
• You cannot use the Last Scene Review function
with SMOOTH SLOW REC.
47