Telephone Base Installation - VTech DS6151 User Manual

Getting started

Telephone base installation

If you have a 2-line wall jack, install the telephone base as shown in
Figure One: Installation with 2-line jack on below.
If you have separate wall jacks for each line, install the telephone base as
shown in Figure Two: Installation with separate line jacks on page 3.
Make sure that the electrical outlet is not controlled by a wall switch.
If you subscribe to digital subscriber line (DSL) high-speed Internet service
through your telephone line, you must install a DSL filter between each
telephone line cord and telephone wall jack. The filter prevents noise and
caller ID problems caused by DSL interference. Contact your DSL service
provider for more information about DSL filters.
Figure One: Installation with 2-line jack
Electrical outlet
not controlled by
a wall switch
Telephone base
power adapter
2
L1+L2 telephone wall jack
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Connect the black
telephone line cord to jack
labeled LINE 1/L1+L2.
Telephone base