Install The Clock Cell - RCA CC616 User Manual

Recording
Install the Clock Lithium Cell
The clock cell indicator
installed or needs to be replaced. The cell should last approximately one year.
Clock Cell
(+ Side Facing Out)
1. Make sure camcorder is turned off, and
remove any power supply attached to
the camcorder.
2. Press release tab of clock cell compart-
ment cover and open the compartment.
3. Insert the clock cell with the "+"
terminal facing out.
4. Close the compartment cover. It will
click into place.
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell –
such as CR2025. Use of other cell presents a risk of fire or explosion.
Must be disposed of properly. Never handle punctured or leaking cell.
May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed.
If swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or
chemical burn if mistreated. Do not recharge, disassemble, heat above
212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the +
and – sides of the cell.
46
will appear in the viewfinder when the cell has not been
Insert object here to remove battery.
Clock Cell
Compartment
To remove battery
To remove battery, insert a pointed non-
metallic object between battery and
compartment and lift.