Installation; Before You Start; Window Installation - Airtemp B6Y12F2A Installation And Operation Manual

Before you start:

Window Requirements:
This air conditioner is factory prepared for installation in standard double-
hung windows with actual opening width of 26 7/8" to 41 5/8" and clear,
vertical opening of 15 5/8" minimum from bottom of sash to sill. Unit can
be installed in 23 7/8" wide window, if cabinet side seals are removed.
Tools Needed
Screwdrivers
Ratchet or Driver with 1/4" socket
Carpenter's Level

Window Installation

Decorative Front Removal
1. Remove the 3/8" phillips screws on either side of the cabinet.
2. Gently pull forward while grasping both sides of the decorative front.
Make sure unit is unplugged before removing the
decorative front.
It is recommended that you have help to install your
unit and that you use proper lifting technique to
avoid personal injury.
Removing the Chassis
1. Remove the two (2) shipping screws from the rear bottom side of the
cabinet. These shipping screws may be discarded.
2. Remove the two (2) anti-theft screws from the bottom front sides of
the cabinet. RETAIN THESE SCREWS, they will be replaced later in
the installation.
3. Slide the chassis out of the cabinet by grasping the base pan handle
and pulling forward while bracing the top bar.
Make sure unit is unplugged before removing chassis
from cabinet.
Filler Panel Frame Installation
1. Slide the filler panel frame onto the air conditioner cabinet using the
tracks on the top bar and bottom bar of the unit. Slide the frame as close
to the air conditioner as possible so that the curtain locks into place.
2. Gently pull the frame out until it is the correct length for your
application.
Use caution when working around exposed sharp edges
of the cabinet and sharp coils to avoid injury or torn
clothing.
Fastener Identification
Installation Parts Kit contents:
Item
Tape Measure
23 7/8" to 41 5/8"
A
Description
1" wood screw
A
5/8" wood screw
B
C
Cabinet
A
Decorative front
B
A
B
C
Shipping screws
A
Cabinet
B
Anti-theft screws
C
B
Top Bar
A
Filler panel frame
B
Filler panel locking edge
C
3

INSTALLATION

WINDOW INSTALLATON
A
B
15 5/8" minimum
B
A B
Qty
1
5
Actual size
A
B
3/8" Phillips screw
C
D
E
Chassis
D
Base pan handle
E
A
C
D
E
Bottom bar
D
Cabinet
E
C