Attaching The Shoulder Strap; Preparing The Remote Control; Attaching The Core Filter To The Usb Cable - JVC GZ-MG467 Manual Book

Attaching the Shoulder Strap

Peel off the pad and thread
the end of the strap through
the eyelet.
Eyelet

Preparing the Remote Control

A battery is included inside the remote control at the time of purchase.
Remove the insulation sheet before use.
Effective Beam Distance
Remote Sensor
NOTE
The transmitted beam may not be effective
or may cause incorrect operation when the
remote sensor is directly exposed to sunlight
or powerful lighting.

Attaching the Core Filter to the USB Cable

Attach the core fi lter to the USB cable. The core fi lter reduces interference. Connect the end of
the cable with the core fi lter to the camera.
Release the stopper.
Thread the strap through the
buckle, adjust its length, and use
the strap guide to fi x it in place.
Strap Guide
Effective distance:
5 m (16 ft)
3 cm (1-3/16")
Position the buckle near the
eyelet and reattach the pad.
Buckle
To Reinsert the Battery
Pull out the battery holder by pressing the
lock tab.
Lock Tab
Lithium Battery
(CR2025)
Wind once.
11