Dubbing To Or From A Video Unit With A Dv Connector - JVC GR-DVL915 Instructions Manual

VIDEO/DSC Switch
(GR-DVL915/DVL815/DVL510 only)
To DV
IN/OUT
Core filter
DV cable
(optional)
Core filter
To DV
IN/OUT
Video unit equipped
with DV connector
PLAY (4)
STOP (5)
To Use This Camcorder As A Recorder . . .
1. Set the VIDEO/DSC Switch to "VIDEO" (GR-DVL915/DVL815/DVL510 only), then turn the Power
Switch to " " while pressing down the Lock Button located on the switch.
2. Set "REC MODE" to "SP" or "LP" in the Menu Screen (
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press the Recording Start/Stop button to engage the Record-Pause mode. "
5. Press the Recording Start/Stop button to start recording.
6. Press the Recording Start/Stop button again to engage the Record-Pause mode.
NOTES:
● Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
"SOUND MODE" setting (
● During Digital Dubbing, no signals are output from the video or audio connectors.
Dubbing To Or From A Video Unit Equipped
With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
[To use this camcorder as a player]
1
2
Lock Button
Power Switch
3
4
NOTES:
● It is recommended to use the AC Adapter as the power supply
● If the remote control is used when both the player and
● If a blank portion or disturbed image is played back on the
● Even though the DV cable is connected correctly, some-
● If "Playback Zoom" (
● When using a DV cable, be sure to use the optional JVC
pg. 47).
Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the illustration.
Set the VIDEO/DSC Switch to "VIDEO" (GR-
DVL915/DVL815/DVL510 only), set the camcorder's
Power Switch to "
Lock Button located on the switch, turn on the video
unit's power, and insert the appropriate cassettes in
the camcorder and the video unit.
Press 4 to play back the source tape.
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
instead of the battery pack (
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press the
buttons on both units.
player during dubbing, the dubbing may stop so that an
unusual image is not dubbed.
times the image may not appear in step 4. If this occurs, turn
off the power and make connections again.
pg. 60), "Playback Special Effects"
(GR-DVL915/DVL815 only,
attempted during playback, only the original playback
image recorded on the tape is output from the DV IN/OUT
connector.
VC-VDV204U DV cable.
pg. 50)
rotates.
EN
" while pressing down the
pg. 9).
pg. 59) or "Snapshot" is
" appears on the screen.
DV. IN
stops rotating.
53