Table of Contents
Advertisement
32
EDITING
EN
Dubbing To Or From A Video Unit
Equipped With A DV Connector
(Digital Dubbing)
It is also possible to copy recorded scenes
from the camcorder onto another video unit
equipped with a DV connector. Since a digital
signal is sent, there is little, if any, image or
sound deterioration.
Core filter
Video unit equipped with DV connector
To use this camcorder as a player
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit
equipped with a DV input connector using a DV
cable as shown in the illustration.
3
Start playback on the camcorder.
(
pg. 19)
4
At the point you want to start dubbing, start
recording on the video unit. (Refer to the video
unit's instruction manual.)
5
To stop dubbing, stop recording on the
video unit, then stop playback on this
camcorder.
To DV OUT
DV cable (optional)
To DV IN
NOTES:
●
It is recommended to use the AC Adapter as
the power supply instead of the battery
pack. (
pg. 13)
●
If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not
dubbed.
●
Even though the DV cable is connected
correctly, sometimes the image may not appear
in step 4. If this occurs, turn off the power and
make connections again.
●
If SNAPSHOT is pressed during playback, only
the original playback image recorded on the
tape is output from the DV OUT connector.
●
When using a DV cable, be sure to use the
optional JVC VC-VDV204U or VC-VDV206U
DV cable.
Advertisement
Table of Contents
